23) Vacuum forming course.
The courses take place from Monday 8 a.m. to Thursday 5 p.m.. 4 nights with breakfast and lunch are included as well as all course documentation.
The vacuum forming course imparts theoretical and practical knowledge about vacuum forming, plastics, machine operation and maintenance. It is a more complete introduction than what is possible during the acceptance test with the customers part.
The course is intended for machine operators but also for management and service personnel of our customers.
Depending on attendance we also try to tackle customer-specific problems. A wide variety of options of our line is also discussed.
A minimum attendance is required. Failing this the course can be cancelled at short notice.
Please note that except for supper all expenses will be accepted by us.
Participants of a vacuum forming course in November 2003 under
direction of service engineers Volker Heine and Walter Schmitt
back to U series
back to T series